Hi everyone . Well I was determined to figure out how to create a Fan Fold card in a size we commonly use for our cards in Australia & I did it ! I won't tell you how much copy paper I went through !
.jpeg)
.jpeg)
So I began with a standard size card - 14.9 cm x 21 cm scored in half @ 10.5 cm .
Then I put a tick mark 4.2 cm from the right side edge & cut from this mark to the bottom right edge of the card stock SAVE THIS OFF CUT
My next layer was 10 x 14.4 cm & the next was my DSP cut @ 9.5 x 13.9 cm & I repeated the steps outline above again using the 4.2 cm tick mark .
Repeat this step on a 10 x 14.4 piece of Basic Whit for the inside of your card .
Fan sizes largest 13x 8.5 cm , 12 x7.5 cm & 11x 6.5 cm - cut in 1/2 diagonally from far left edge to far right edge
smallest fa sizes - use off cut saved from card base 3.5 x14 & 3 x 13 cm.
Please watch my video for assembly instructions .
No comments:
Post a Comment